How does a blinking LED circuit work?

The circuit for blinking an LED using transistors is called an Astable Multivibrator. The two capacitors C1 and C2 will alternate between being charged and discharged and thereby turning the transistors ON and OFF. When a transistor is ON it allows current to flow through it so that the LED above it will light up.

How do you make a LED circuit blink?

Let’s get started:

1. Step 1: Add the Transistors. Add the two PNP transistors and the jumper wires from the power BUS to the emitter of each transistor.
2. Step 2: Add the Capacitors.
3. Step 3: Add the 100K Resistors.
4. Step 4: Add the LEDs.
5. Step 5: Supply Power and Watch the LEDs Blink.
6. 16 People Made This Project!
7. 68 Comments.

What is a flashing LED?

Flashing LED Light This flashing LED circuit is nothing but a low-current drain flasher. It uses a single CMOS timer that is configured as a free running oscillator using a few additional components.

What is the use of blinking LED?

LED blinking circuit can be used as flashing beacon. LED blinking circuit can be used as vehicle indicator when it is broke down in the middle of the road. It can be used in operation theaters or offices as an indication that you are engaged in work. There are lots of applications with these two circuits.

What’s the purpose of a blinking LED circuit?

The blinking LED circuit is like the electronics version of the “Hello World”-program. It’s a simple electronic circuit that gives you a visual cue if it works. It was the first circuit I ever built, and it felt GREAT! The goal is to make a Light Emitting Diode (LED) blink.

How are LEDs flash on and off in a circuit?

Someone calls a blinking LED circuit. They have two LEDs flash alternately. There are many ways to flash LEDs on and off using transistors. We may call it that Free Running Multivibrator. It works like Flip Flop that triggers itself repeatedly.

How did I learn the flashing light circuit?

He drew a small circuit diagram consisting of a relay, a light bulb and a battery. It was the flashing light circuit. Then he explained “You see, when the relay is powered, the switch will disconnect the power from the relay coil and connect the power to the lamp instead so that it will light up.

Can a flashing LED be used as a police light?

The above circuit can be suitably modified for producing a revolving, flashing police light effect to the above constructed circuit. Here by adding a network of a zener diode / resistor / capacitor, to the output of the circuit, just as shown in the figure, we can acquire a very peculiar effect with the generated illuminations of the LED.