Users' questions

How do I reset my Cisco switch password?

by Rhyley Bryan

How do I reset my Cisco switch password?

Find the below steps to recovery password for Cisco 2960.

  1. Power off the switch first, then press and hold the mode button while you power on the switch again.
  2. To initialize the flash file system, run the command:
  3. You can now list the contents of your flash by running.
  4. To further boot the switch run the boot command as:

How do I recover my Cisco router password?

Step-by-Step Procedure

  1. Either switch off or shut down the router.
  2. Remove the compact flash that is on the rear of the router.
  3. Switch on the router.
  4. Once the router is on Rommon mode, reinsert the compact flash.
  5. Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash.
  6. Type reset at the rommon 2> prompt.

How to do a password reset on a Cisco 3560?

Cisco 3560-X Password Reset Unplug Cisco 3560-X power Hold down “Mode” button on front, and plug in power Continue to hold “Mode” for about 15 seconds, until the SYST LED turns solid green, then release Log into the switch via console, you should see the “switch:” prompt Enter the command flash_init

How to recover username and password on 3560 switch?

INCLUDING !!! the username and password. While you still have access since it shouldn’t kick you just type a new username and password or remove the old for future access. 08-06-2015 12:23 PM 08-06-2015 12:23 PM Are you able to reboot the 3560? Make sure to save your config first with “copy run start”

How to reload privileged exec in catalyst 3560?

Step 12 Boot the newly downloaded Cisco IOS image. Step 13 Use the archive download-sw privileged EXEC command to download the software image to the switch. Step 14 Use the reload privileged EXEC command to restart the switch and to verify that the new software image is operating properly.

How to enable or disable password recovery in catalyst?

You enable or disable password recovery by using the service password-recovery global configuration command. Follow the steps in this procedure if you have forgotten or lost the switch password. Step 1 Connect a terminal or PC with terminal-emulation software to the switch console port.