How do I setup a Cisco site to site VPN?
How do I setup a Cisco site to site VPN?
Router A Cisco CP Configuration
- Choose Configure > Security > VPN > Site-to-Site VPN, and click the radio button next to Create a Site-to-Site VPN.
- Choose Step by step wizard in order to proceed with the configuration, and click Next.
- In the next window, provide the VPN Connection Information in the respective spaces.
How do I connect my site to site VPN?
To set up a Site-to-Site VPN connection, complete the following steps:
- Prerequisites.
- Step 1: Create a customer gateway.
- Step 2: Create a target gateway.
- Step 3: Configure routing.
- Step 4: Update your security group.
- Step 5: Create a Site-to-Site VPN connection.
- Step 6: Download the configuration file.
How do I configure Strongswan site to site VPN?
- In order to configure a site to site VPN, you will need to have the following:
- (192.168.100.0/24) Server A 1.1.1.1< — — — Internet — — — — -> 2.2.2.2 Server B (10.1.1.0/24)
- STEP 1: Install the VPN Tool.
- Linux:
- STEP 2: Configure the VPN Tool.
- The above command sets up ip forwarding and redirects for the tunnel.
What is Cisco ASA site to site VPN?
Cisco ASA Site-to-Site IKEv1 IPsec VPN. Site-to-site IPsec VPNs are used to “bridge” two distant LANs together over the Internet. Normally on the LAN we use private addresses so without tunneling, the two LANs would be unable to communicate with each other.
How to configure Cisco ASA 5500 VPN tunnel protocol?
For a list of all possible attributes, refer to the Configuring Group Policies section of the Selected ASDM VPN Configuration Procedures for the Cisco ASA 5500 Series, Version 5.2. The vpn-tunnel-protocol attribute determines the tunnel type to which these settings should be applied. In this example, IPsec is used: vpn-tunnel-protocol ?
Do you need certificate mode for Cisco ASA 5505?
You may have higher security requirements in which you mix with certificate mode, but we don’t need it for our lab. Next, leave the default for “Encryption Algorithms” and click “next.” Don’t click anything on Miscellaneous other than “Exempt ASA side host/network from address translation (inside)” in the drop down.
How to setup a site to site VPN in ASDM?
Complete these steps: Log in to the ASDM, and go to Wizards > VPN Wizards > Site-to-site VPN Wizard. A site-to-site VPN Connection setup window appears. Click Next. Specify the Peer IP Address and VPN Access Interface.
How to configure site to site VPN tunnel?
This section describes how to configure the site-to-site VPN tunnel via the Adaptive Security Device Manager (ASDM) VPN wizard or via the CLI. This is the topology that is used for the examples throughout this document: Complete these steps in order to set up the site-to-site VPN tunnel via the ASDM wizard: