Is 8Cr14MoV good knife steel?

8Cr14Mov and it’s variants (including 8Cr14MoV) is actually excellent steel for the money. It isn’t a super steel, but it is very adequate stainless steel, is far better than “no name steel” and is found in a lot of high value knives.

What is AUS 8 steel?

What Is AUS-8 Steel? AUS-8 steel is Japanese made, very similar to 440 steel but with vanadium added to provide more hardness. This is an upper medium quality steel that is favored by many knife makers and designers for its cost-effectiveness as well as its corrosion resistance.

Is the 8Cr13MoV steel good for knives?

Yes, 8cr13mov steel is good for knives. In fact, it is commonly used by manufacturers like A.G. Russell Knives, CRKT, Kershaw . As knife steel, the 8cr13mov holds up well against daily use.

Is the 9cr18mov steel a good steel?

In general, I find the 9Cr18MoV very great and affordable steel, especially for kitchen knives, many Damascus knives are made from it, it offers great corrosion resistance, and it holds an edge pretty good, it’s like owning a premium kitchen knife for a low/mid-range price (Great trade!), let’s not forget that it can be great for EDC knives.

What is the Rockwell hardness of 8Cr13MoV steel?

The Rockwell hardness of 8Cr13Mov is a maximum of 62HRC. For more information about “ Rockwell Hardness” and “HRC ” Read this Post. According to the chemical composition and the HRC of the steel, the 8Cr13Mov Steel has the following features:

Which is better 8Cr13MoV or d20 steel?

When looking at 8cr13mov steel compared to D20 steel, 8cr13mov steel has better corrosion resistance and sharpness than D20 steel. However, if you are prioritizing toughness and edge retention then D20 would be the steel to go with. The 440C steel has a higher carbon and chromium content in it than the 8cr13mov.