How do I program my Silverado key?

Hold down the “unlock” and “lock” button on your keyless-entry remote until your doors respond by cycling again. This will indicate that the programming was successful. Once the doors cycle again turn the key in the ignition back to “on”. Congratulations, you have successfully programmed your chevy key fob!

How do you reset the security system on a 2007 Chevy Silverado?

In a chevy silverado, you will try to reset the anti-theft system by turning the key on until the yellow lock goes out on the instrument panel for about 10 minutes. Turn the key off and do it 2 more times after 3 cycles, pull the key and put it back in.

Can a dealership cut a key with just the VIN number?

Most vehicles in the United States from 1990 and up have key codes that are saved on file with the manufactures. As long as you can prove ownership of your vehicle a car key can be made with the Vehicle Identification Number aka VIN number. Once a key code is pulled from the VIN number a car key can be cut.

How do I program my ignition key?

Programming a Single Key

1. Insert the key into the ignition, and turn it to the on position.
2. Leave the key in this position for 10 minutes and 30 seconds, and then turn it off.
3. Turn the key back on, and wait for additional 10 minutes and 30 seconds before turning it off again.
4. Repeat the process for a third time.

How do I reset my anti-theft system?

Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car.

What happens if I lost my car key and don’t have a spare?

If you lose it: You could call a locksmith, who can come and make you a new key on the spot. In some cases—an unusual or older vehicle—a locksmith may not be able to help. You might need to buy a new ignition lock cylinder and key from the dealer or an independent repair shop.

How can I get my car key without a key?

An experienced locksmith will be able to make a replacement key for you even if you do not have the original. When you contact a locksmith, you’ll need to give the company some information about the key, and then they will likely be able to help you replace it.

How do I reset my suburban key fob?

INSERT key into Ignition and TURN the Ignition to ON/ACC (just shy of cranking engine). PRESS the Trip Odometer Reset button until “RELEARN REMOTE KEY” is displayed. PRESS and HOLD the Trip Odometer Reset Button for 3 seconds until “REMOTE KEY LEARNING ACTIVE” displays. Vehicle is now in Programming Mode.

How to program a Chevrolet Silverado remote key fob 2007?

An easy to follow video on how to program a remote key fob for a 2007 – 2010 Chevrolet Silverado. 1. Insert Key and turn to ON position so you can access Driver Information Center 2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays 3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays 4.

How do you program a Chevy Silverado ignition key?

1. Insert an existing programmed working key into the ignition cylinder. 2. Turn ignition to the ON position for 5 seconds, then back to OFF position. 3. Remove the existing key and within 5 seconds insert new key and turn it to the ON position for 5 seconds. 4. Turn key OFF then back to ON. The key is now programmed. Start vehicle to test key.

How to enter programming mode on a Chevy Silverado?

1 Close All Doors CLOSE all doors. 2 Enter Programming Mode – Step 1 INSERT key into the Ignition (DO NOT TURN). 3 Enter Programming Mode – Step 2 PRESS and HOLD the power UNLOCK button on the Driver’s side door.

How do you reset the remote on a Chevy Silverado?

Time needed: 5 minutes. INSERT key into Ignition and TURN the Ignition to ON/ACC (just shy of cranking engine). PRESS the Trip Odometer Reset button until “RELEARN REMOTE KEY” is displayed. PRESS and HOLD the Trip Odometer Reset Button for 3 seconds until “REMOTE KEY LEARNING ACTIVE” displays.