Popular tips

What does the plug on an alternator do?

What does the plug on an alternator do?

Identify the third wire, which is typically two wires with a snap-in plastic connector on the alternator end. If the voltage rises above or falls below 12 Volts, the alternator’s internal voltage increases or reduces power output to maintain 12 Volts to the battery and the systems of the vehicle during operation.

What are the wires on an alternator?

Locate the terminal on the alternator labeled “B”, “Bat” or “Pos.” All alternators have this terminal. The wire that connects to it is red and goes to the battery. It is a heavy duty wire as it has to carry high current.

Where is the voltage regulator on an alternator?

The voltage regulator is located inside the alternator. When the voltage regulator fails the entire alternator is usually replaced. It should be on the alternator or internal to the alternator. There will be an oblong plug for it so just look for the connecter.

What is voltage regulator and how does it work?

A voltage regulator is basically a beefed up emitter follower, like described above – a transistor connected to a stable reference that spits out a constant voltage, dropping the rest. They also have a built in error amplifier, which samples the output voltage (again through a divider), compares it with the reference voltage, calculates the difference, and drives the output transistor accordingly.

What is an alternator controller?

Alternator Controllers Also known as Alternator Regulators, they control the way the alternator charges the batteries. Some specialist alternators do not contain any form of regulation. They simply will not work without an external regulator. Obviously if your alternator is of this type then you have no choice,…

What is a voltage regulator circuit?

A Voltage Regulator is an integrated circuit that outputs a specified DC voltage. An example of this is a 5-volt regulator, such as the LM7805, which provides a consistent voltage of 5 volts. Voltage regulators are necessary in applications where a certain constant and consistent level of DC voltage is needed in a circuit.