How do I reset my Fargo HDP5000 printer?

Rebooting the Printer

1. 1 Select the Administration link.
2. 3 Select the Reboot link.
3. 4 Select the Reboot button.
4. 5 Click Yes when prompted.

How do I calibrate my Fargo HDP5000?

To Calibrate Your Printer Right click on the Fargo HDP5000, and choose Printing Preferences. Click on the Calibrate Film tab. Follow the instructions listed on this tab, and then click Calibrate.

How do I update my HDP5000 firmware?

How to Update Firmware

1. Open the Fargo Workbench and choose your HDP5000 printer.
2. Click on the Update Manager tab, and then choose your HDP5000 printer again.
3. Check the button for Select Firmware File, and browse to the firmware file you downloaded. Click on Begin Updating.

How do I set up Fargo HDP5000?

Setup Using Fargo HDP5000 Card Printer

1. Step 1 – Connect Printer to Network.
2. Step 2 – Install Smart Card Reader(s) Driver(s)
3. Step 3 – Install Smart Card Printer Driver.
4. Step 4 – Configure Card Printer vSEC:CMS.
5. Step 5 – Create Smart Card Batch Issuance File.
6. Step 6 – Create Smart Card Design Layout.

How to troubleshoot a hid Fargo hdp5000?

hoose “Fargo” and then “HDP5000” or “HDP5600” (depending on your model) from the second drop down list. You will need the download the printer driver, Fargo Workbench and the printer firmware. Upgrading the printer driver Attention:Before you start, unplug the printers USB cable. 1. Click the windows “START” button / icon 2.

What to do if your Fargo ID card gets stuck in the printer?

Verify the Cleaning roller is properly installed on the Ribbon Cartridge. Check for card slippage. If necessary, run the Printer cleaning routine. Verify that your cards are within the accepted card size range. Verify the cards are not sticking together. My cards get stuck in the printer (errors # 82, 83, 112, and 200). What do I do?

How often should I Clean my Fargo ID card printer?

Perform this procedure approximately every 1,000 prints to maintain a consistent print quality. From the HDP5000 Driver, click on the Toolbox button to bring up the Clean Printer tab. Remove cards, film, laminates from the printer. Use the Cleaning Card from the Printer’s and remove the adhesive backing from both sides of the card.

Who is the creator of the hdp5000 printer?

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4), property of Fargo Electronics, Incorporated Copyright © 2007 by Fargo Electronics, Incorporated. All rights reserved. Printed in the United States of America.