How do I fix error code C0055?

How to diagnose and repair C0055

1. Perform a preliminary inspection. Sometimes C0055 can pop up intermittently.
2. Check for other DTCs.
3. Scan tool check.
4. Check the VSS.
5. Check the WSS circuit.
6. Check the ABS module.

What is code C0055?

C0055 00. An open is detected on the rear wheel speed sensor signal circuit. A short to ground is detected on the rear wheel speed sensor signal circuit. A short to voltage is detected on the rear wheel speed sensor signal circuit.

Where is the speed sensor located on a 2005 GMC Envoy?

The speed sensor is located in the rear axle.

Where is the wheel speed sensor?

Wheel speed sensors are often called ABS sensors. You’ll find them mounted on the axles of all ABS equipped vehicles. Look for this sensor on your wheel hubs, near the brake rotors. You’ll find the rear wheel speed sensor mounted on the rear axle housing or wheel cylinder.

What does the ABS code c0055 stand for?

Code C0055 indicates the ABS module has determined a problem with the rear wheel speed sensor (vehicle speed sensor) or its circuit. Code C0055 is typically caused by one of the following:

What does the codes c0055 and c0201 mean?

C0201 is ABS module fault. Under. Truck under drivers seat is the pump and module. Unplug it and check for moisture and corrosion. Clean and add DIEELECTRIC gel. Clear codes and retest. Might need another module. You don’t need to remove pump just unbolt module from pump.

How to fix code c0055 Chevrolet rear wheel?

How do I fix code C0055 CHEVROLET? Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. How much do you know about cars? The cost of diagnosing the C0055 CHEVROLET code is 1.0 hour of labor.