How do bezels set small stones?

First, make sure your stone fits snugly in the setting by putting it in the bezel setting. View it from the side to make certain it sits level in the bezel cup. Next, begin pushing the bezel edge in around the stone using a bezel roller. Push one side gently against the stone, then push on the opposite side.

How do you put a stone in a pendant?

1. Step 1: Thin the Prongs. Hold the pendant setting securely on the peg.
2. Step 2: File the Prongs. Using a flat needle file, file the top of the prongs to an angle of about 45 degrees.
3. Step 3: Set the Stone. Insert the stone and push the tips of the prongs over the stone.
4. Step 4: The Finishing Touch.

What do you need for stone setting jewelry?

Bezel-Setting Tools & Supplies You’ll Need Product Type Product Name Cost Cylinder Bur Maillefer Jewelry Swiss Harden Tool Stee $ Stone Pushers Bezel Roller, Square Prong – PSH300 $ Milgrain Tool Set Milgrain Tools, Set of 6 | MLG-200.00 $$ Hammer Handpiece for Rotary Tool Hammer – H-15 $$$

How are the stones set in a flush set?

The stones are set down into the metal without beads or prongs as in this wedding band. The tables of the stones are set even with the metal surface in a modified bezel. This is where the name ‘Flush Set’ is derived from, as the stones are set flush with the metal. Flush setting is an advanced setting procedure.

How are stone settings made in ganoksin jewelry?

In the case of parallel walled frames, an inner bearing is cut or added to support the stone; in the case of conical settings, the decreasing size of the form supports the stone from behind. In both cases there must be sufficient metal above the stone to press over it. This is what secures it in place.

What’s the best way to tighten royal flush stone?

Do not attempt to tighten the stone by hammering on the metal surface forcing metal over the stone. This causes a dip in the surface surrounding the stone, resulting in an unsatisfactory appearance. Burnishing the metal over the stone is the preferred method of tightening the stone. If you cut the seat properly, you will not need to use a hammer.