Users' questions

How can I remove the write protection from my USB?

How can I remove the write protection from my USB?

Type “Attributes disk clear readonly” and press “enter.” Yes, that word is spelled as “readonly.” Finally, wait for the write protection removal to finish, type “Exit”, then hit “enter” to close the command prompt window. Restart your PC and try writing on the USB again after the system has rebooted.

How do I remove write protection from USB fat32?

Disable Write Protection Using Diskpart

  1. diskpart.
  2. list disk.
  3. select disk x (where x is the number of your non-working drive – use the capacity to work out which one it is)
  4. clean.
  5. create partition primary.
  6. format fs=fat32 (you can swap fat32 for ntfs if you only need to use the drive with Windows computers)
  7. exit.

How do I disable write protected USB?

Disable the Write protection from USB Drives. If you want to disable the write protection settings, simply navigate to the above registry key and delete the WriteProtect registry entry. You may also change the value to 0. This will save you time and effort, if you want to enable the write protection at a later time.

How do you undo write protection?

To remove the write protection, simply open your Start menu, and click on Run. Type in regedit and press Enter. This will open the registry editor.

How to unprotect the memory card?

Please follow the steps below: Turn your camera off. On the side, you will see a compartment that has the SD memory card. You will see a black button, upon pressing which, the memory card will be ejected. Once you press this button and have the memory card in your hand, you will see a plastic switch on it. Insert the memory card back in and switch on your camera.

How to remove write protection on SD card [4 ways]?

Remove Write Protection on SD Card Method 1. Remove Write Protection on an SD Card via Modify Registry Method 2. Remove Write Protection on SD Card with Disk-part Utility. You can also fix SD card with Disk-part Utility. Click the Start button then type in “cmd”. Method 3. Reset the Card’s Attribute. A command prompt can also be used to clear memory card write protection. See More….