What does F01 mean on Indesit washing machine?
What does F01 mean on Indesit washing machine?
Electronic circuit board fault
F01 — Electronic circuit board fault. Issue: Washing Machines is not operating – some or all functions are not selectable. Advice: We recommend you disconnect (unplug) the appliance from the mains supply for a minimum of 2 minutes. Reconnect supply and wait 30 seconds and try starting the machine again.
How do I reset my Indesit washing machine?
Indesit washing machine factory reset instructions are as follows:
- Switch off the power and unplug the machine.
- Turn on the machine using the on/off button.
- Set the timer control to the zero position.
- Plug the machine back in.
- Switch on the power.
- The display lights should now be flashing.
Why is my Indesit washing machine flashing F12?
F12 indicates that the upper control board is not communicating with the main control board, check its wiring and its connections.
What is the fault code for an Indesit washing machine?
The codes go from F01 to F18. Indesit washing machine fault Code F05 for example signifies a waste pipe blockage or a pump issue. This means that the door may not open. Or if it does the water stays inside the drum. Your engineer will check for blockages in the pump filter, waste hose, and all plumbing under the sink.
What to do if you get an Indesit error code?
Created with sketchtool. Action: We recommend you check that the drain pipe and under sink plumbing for any blockages. Action: Please check that the water supply is present and of sufficient pressure, also that the tap is fully on and that the fill hose is not restricted.
Is there a recall on Indesit hot point washing machine?
Safety Notice: A recall has been launched relating to the door lock system for certain Hotpoint and Indesit washing machines. Find out more here. Issue: During a wash cycle the programme pauses part way through/ the machine is not heating and the pump runs continuously.
How long to disconnect Indesit from mains supply?
Advice: We recommend you disconnect (unplug) the appliance from the mains supply for a minimum of 2 minutes. Reconnect supply and wait 30 seconds and try starting the machine again.